Skip to content
RemoteMikroTik

Troubleshooting

"The router refused the panel's login"

Usually fixed by running the setup script again.

1 min read · Updated

The tunnel works, but the panel's own user can't log in to the router. Then Test connection, the live bandwidth monitor, backups and the Telegram tools fail, while Winbox with your own login may still work.

Common causes

  • The rm_ user was deleted or its password changed on the router.
  • The API service is disabled, or limited to addresses that don't include the tunnel gateway.
  • The router was reset or replaced.

Steps

  1. Copy the setup script from the router's page again and run it. It recreates the panel's user and enables the API for the tunnel if it was off.
  2. If you limit the API to certain addresses, add the tunnel gateway from the script, for example: /ip service set api address=192.168.88.0/24,10.169.0.1/32.
  3. Press Test connection on the router's page. You should see the router's name and version.

If backups now say the router's SSH key changed (after a reset or replacement), see Backups paused.

Still stuck? Open a support ticket and tell us which step didn't work.